1. Boot the computer using the XP CD. You may need to change the
boot order in the system BIOS. Check your system documentation
for steps to access the BIOS and change the boot order.
2. When you see the “Welcome To Setup” screen, you will see the
options below This portion of the Setup program prepares Microsoft
Windows XP to run on your computer:
To setup Windows XP now, press ENTER.
To repair a Windows XP installation using Recovery Console, press R.
To quit Setup without installing Windows XP, press F3.
3. Press Enter to start the Windows Setup.
do not choose “To repair a Windows XP installation using the
Recovery Console, press R”, (you do not want to load Recovery
Console). I repeat, do not choose “To repair a Windows XP
installation using the Recovery Console, press R”.
4. Accept the License Agreement and Windows will search for existing
5. Select the XP installation you want to repair from the list and
press R to start the repair. If Repair is not one of the options,
read this Warning!!
6. Setup will copy the necessary files to the hard drive and reboot.
Do not press any key to boot from CD when the message appears.
Setup will continue as if it were doing a clean install, but your
applications and settings will remain intact.
Blaster worm warning: Do not immediately activate over the internet
when asked, enable the XP firewall
[ http://support.microsoft.com/?kbid=283673 ]
before connecting to the internet. You can activate after the
firewall is enabled. Control Panel – Network Connections. Right click
the connection you use, Properties, and there is a check box on the
Advanced [ http://michaelstevenstech.com/xpfirewall1.jpg ] page.
7. Reapply updates or service packs applied since initial Windows XP
installation. Please note that a Repair Install from the Original
install XP CD will remove SP1/SP2 and service packs will need to be
Service Pack 2
An option I highly recommend is creating a Slipstreamed XP CD with SP2.
Slipstreaming Windows XP with Service Pack 2 (SP2)
If the option to Repair Install is not available and you continue
with the install;you will delete your Windows folder and Documents
and Settings folder. All applications that place keys in the registry
will need to be re-installed. You should exit setup if the repair
option is not available.
Warning!! If the Repair Option is not Available
What should I do? Most important do not ignore the information below!
If the option to Repair Install is NOT available and you continue
with the install; you will delete your Windows folder, Documents and
Settings folders. All Applications that place keys in the registry
will need to be re-installed.
You should exit setup if the repair option is not available and
consider other options. I have found if the Repair option is not
available, XP is usually not repairable and will require a Clean
If you still have the ability to access the Windows XP installation,
backup all important files not restorable from other sources before
attempting any recovery console trouble shooting attempts.
Possible Fix by reconfiguring boot.ini using Recovery Console.
1.Boot with XP CD or 6 floppy boot disk set.
2. Press R to load the Recovery Console.
3. Type bootcfg.
4. This should fix any boot.ini errors causing setup not to see the
XP OS install.
5. Try the repair install.
One more suggestion from MVP Alex Nichol
“Reboot, this time taking the immediate R option, and if the CD
letter is say K: give these commands
COPY K:i386ntldr C:
COPY K:i386ntdetect.com C:
(two other files needed – just in case)
1. Type: ATTRIB -H -R -S C:boot.ini DEL C:boot.ini
2. Type: BootCfg /Rebuild
which will get rid of any damaged boot.ini, search the disk for
systems and make a new one. This might even result in a damaged
windows reappearing; but gives another chance of getting at the